For instance, if you wanted Bands A and B to be setup to cover 25.165 - 26.055 MHz, Band C to be the CB Band 26.965 - 27.405 MHz, then Bands D, E, and F to cover 10 Meters at 28.315 - 29.655 MHz, the “Programming Mode” can be used to set this up. Programming Mode: Channel Board Remove Metal Cover PCBX-0335R3A Jumper Diagram This feature allows the radio to be setup into 8 separate bands, each individually programmed to cover any 40 channel segments you choose between 25.165 - 30.555 MHz. The jumper setting for this mode is JP1 = ON JP2,JP3 = OFF JP4 = ON. Export Mode: This mode is pre-set to 8 Bands between 25.615 MHz - 29.205 MHz. The jumper setting for this is JP1, JP2, JP3 = OFF and JP4 = ON. (See Programming Mode) 10 Meter Only Mode: The default setting from the factory covers only 4 bands between 28.065 MHz - 28.525 MHz. The radio can also be programmed to cover all frequencies in 10 KHz or 5 KHz steps between 26.000 - 32.990 MHz. These 8 bands can be programmed to any combination of Eight 40 channel blocks between 25.615 - 30.555 MHz. The frequency range can be extended for Export Use in 8 Band segments each containing 40 Channels. MAGNUM S9 EXPORT FREQUENCY CONVERSION JP102 Jumper Block JP1 JP2 JP3 JP4 Introduction: The Magnum S9 is programmed for the 10 Meter Amateur Band out of the box, and covers a range of 28.065 - 28.525 MHz.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |